Annealing - Gunner Forum
Gunner Forum

Annealing

This is a discussion on Annealing within the Ammunition forums, part of the Gunner Forum category; I shoot 7.92x33. I bought a annealing turn table several years ago. I think it was around $650. I ve never used it. thought of ...


Go Back   Gunner Forum > Gunner Forum > Ammunition

Reply
 
LinkBack Thread Tools Display Modes
Old 10-15-2016, 08:54 AM   #1
Member
 
Joined: Sep 2016
From: georgia
Posts: 38
Annealing

I shoot 7.92x33. I bought a annealing turn table several years ago. I think it was around $650. I ve never used it. thought of doing some reloading this winter. do you resize and then anneal or does it matter when you anneal
henryb is offline  
Register

Welcome to Gunner Forum - a friendly gun forum for gun owners.

We welcome everyone and the community is free to join so register today and become part of the Gunner Forum family!

Old 10-15-2016, 12:27 PM   #2
Senior Member
 
tx gun runner's Avatar
 
Joined: Jun 2008
From: Ft Hood , Tx area
Posts: 11,626
You should anneal 1st before resizing case . Not all brass need to be annealed . I've reloaded the brass below over 90 times in 16 yrs in these 6 guns . My 270 Winc I had to anneal every the brass after only 5 firings . My 308 winc has been over 30+ firing never were annealed but they where neck sized only and still never lost a case . So only do them if the need it .
Attached Images
File Type: jpg e77a476a-1821-4a2e-920f-cfd4508bd778.jpg (352.8 KB, 5 views)
File Type: jpg IMG_0001-6.jpg (34.4 KB, 4 views)
tx gun runner is offline  
Old 10-15-2016, 01:33 PM   #3
Member
 
Joined: Sep 2016
From: georgia
Posts: 38
have loaded some in the past. seemed like the bullet wasnt real tight fitting,not all where like this only ones that had been reloaded several times
henryb is offline  
 
Old 10-16-2016, 06:46 AM   #4
Senior Member
 
tx gun runner's Avatar
 
Joined: Jun 2008
From: Ft Hood , Tx area
Posts: 11,626
If I load boat tail bullets , I take the expander button out of the dies and press the bullet in . If I use flat base bullet I sometimes take the expander button out of dies and put it in a drill and sand the button to a smaller dia to make the grip on the bullet tighter . If you find bullet pressing in tight and loose you could need to neck turn the brass .
tx gun runner is offline  
Reply

  Gunner Forum > Gunner Forum > Ammunition

Thread Tools
Display Modes



Top Gun Sites Top Sites List


Powered by vBulletin 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © 2008-2012 Gunner Forum. All rights reserved.